1. Surface cleaning and preparation
Ensure that the bonded surface is clean: Before use, be sure to clean and remove oil, dust, moisture and other impurities from the bonded surface. These pollutants will affect the adhesive effect of the tape, resulting in reduced adhesive force or adhesive failure.
Drying treatment: Ensure that the bonded surface is completely dry, as a wet surface will also affect the adhesive properties of the tape.
2. Temperature and humidity control
Pay attention to the ambient temperature: Use the tape within the applicable temperature range and avoid using it under extreme conditions of high or low temperature, so as not to affect the adhesive force and durability of the tape.
Humidity management: Try to operate in an environment with low relative humidity to reduce the impact of moisture in the air on the adhesive effect of the tape.
3. Correct pressure and positioning
Uniform pressure: During the pasting process, it should be ensured that uniform pressure is applied to the tape to make the adhesive fully contact with the bonded surface and improve the bonding effect.
Accurate positioning: Before pasting, the position of the tape should be accurately measured and determined to avoid dislocation or offset and ensure the quality of adhesion.
4. Avoid over-stretching and twisting
Prevent stretching: During the pasting process, excessive stretching of the tape should be avoided, so as not to damage its internal structure, affecting the adhesive force and service life.
Prevent distortion: Ensure that the tape is kept flat during the paste process and avoid twisting or folding, so as not to affect its adhesion performance and appearance quality.
5. Storage and shelf life
Storage conditions: Tape should be stored in a cool, dry, well-ventilated place, away from direct sunlight, high temperature or humid environment.
Pay attention to the shelf life: pay attention to the shelf life of the tape, avoid using expired products, so as not to affect the bonding effect and use safety.
6. Later inspection and maintenance
Regular inspection: After use, the adhesive part should be checked regularly to ensure that the tape does not fall off, loose or damaged.
Timely maintenance: If the tape is loose or damaged, repair or replace it in time to ensure the normal operation and safety of the device.
